Installation Instructions
Installation Instructions
CAD Drawings

Fourth graders with their Iditarod Sled Dog Race projectSunrail Nautilus Design Installation Guide

Fourth graders with their Iditarod Sled Dog Race projectSunrail Mariner -Cad

Fourth graders with their Iditarod Sled Dog Race projectSunrail Mariner Design Installation Guide

Fourth graders with their Iditarod Sled Dog Race projectSunrail Glass-Cad

RailEasy Nautilus Installation Guide

Fourth graders with their Iditarod Sled Dog Race projectSunrail Nautilus-Cad

Fourth graders with their Iditarod Sled Dog Race projectMariner design and Installation Guide

Fourth graders with their Iditarod Sled Dog Race projectMariner-Cad

Fourth graders with their Iditarod Sled Dog Race projectTurnbuckle Installation Guide

Fourth graders with their Iditarod Sled Dog Race projectVanguard-Cad

Fourth graders with their Iditarod Sled Dog Race projectCutting Stainless Steel Railing Instructions

Fourth graders with their Iditarod Sled Dog Race projectNautilus-Cad

Fourth graders with their Iditarod Sled Dog Race projectMicrostar Installation Guide

Fourth graders with their Iditarod Sled Dog Race projectConcrete Base Installation Guide


Rail Easy Turnbuckle Installation

Just 4 Easy Installation Steps installing cable rail

Step 1 – Cutting Cable to length

Screw all turnbuckle receiver screws out evenly about ½” for every 20 ft of run. Measure the length of Cable required from the hex of the cone to the opposing turnbuckles hex of the cone. Cut a piece of Cable, using the special cutters. step 1 install cable rail

Step 2 - Seat Cable in the Turnbuckle receiver.

Unscrew the cone but do not disassemble completely. Push the end of the Cable through the cone and wedge till it seats fully in the receiver, twist if necessary to seat fully. Tighten the cone on the receiver till aluminum wedge locks the Cable in place. step 2 install cable rail

Step 3 - Tighten cone onto receiver.

Tighten the cone on the receiver till aluminum wedge locks the Cable in place. step 3 install cable rail

Step 4 - Rotate body to tension wire rope.

Placing an allen wrench through the hole in the back of the RailEasy Turnbuckle and a wrench on the bolt just below the cone, rotate the allen wrench to Tension Cable and complete assembly. step 4 install cable rail